Machinist needed!!!
Close
    
    
Results 1 to 4 of 4
  1. #1
    Senior Member flyhunter3825's Avatar
    Join Date
    Nov 2012
    Location
    DePere, Wisconsin
    Posts
    296

    Machinist needed!!!

    I need my triples bored out from 33mm to 36mm and the shops around here are either too busy or they cost waaaay too much for what i need done. The first set i did was with an adjustable hand reamer. It did an ok job, but i was not satisfied. Is there anyone here with a connection or has the tooling to do this? Thanks!

  2. #2
    Junior Member Sabmag's Avatar
    Join Date
    Oct 2014
    Posts
    1
    Quote Originally Posted by flyhunter3825 View Post
    I need my triples bored out from 33mm to 36mm and the shops around here are either too busy or they cost waaaay too much for what i need done. The first set i did was with an adjustable hand reamer. It did an ok job, but i was not satisfied. Is there anyone here with a connection or has the tooling to do this? Thanks!
    I have my own engine machine shop that specializes in powersports and such. I could set them up in the Bridgeport and bore them out. pm me

  3. #3
    Senior Member scotti158's Avatar
    Join Date
    May 2013
    Location
    Groton, NY
    Posts
    2,663
    Is there enough "meat" to bore out that far?
    2013 Yamaha TW200

    1996 Yamaha TW200

    1995 Kawasaki KLR650

    2002 Yamaha RoadStar 1600 with sidecar

  4. Remove Advertisements
    TW200Forum.com
    Advertisements
     

  5. #4
    Senior Member flyhunter3825's Avatar
    Join Date
    Nov 2012
    Location
    DePere, Wisconsin
    Posts
    296
    Quote Originally Posted by scotti158 View Post
    Is there enough "meat" to bore out that far?
    Plenty. Its only 1.5mm in either direction. I dont plan on jumping the bike, lol. Its more of a crawler. Ive got 6 inches of lift in the rear and i need to even it out in the front.

Sponosred Links

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Similar Threads

  1. Bars needed
    By Schmitty in forum TW200 Classifieds
    Replies: 2
    Last Post: 08-24-2014, 07:28 PM
  2. parts needed
    By jtomelliott49 in forum TW200 Classifieds
    Replies: 0
    Last Post: 06-14-2013, 02:19 PM
  3. I needed 450 more ccs
    By triple3jrb in forum General Discussion
    Replies: 36
    Last Post: 05-20-2012, 05:39 AM
  4. Little help needed!!!
    By Dvorocks in forum Performance and Customization
    Replies: 3
    Last Post: 05-17-2012, 06:53 PM
  5. tw needed
    By phazer in forum TW200 Classifieds
    Replies: 1
    Last Post: 11-06-2011, 05:28 PM