I didn't know they made these. Check out the mounted picture. Application chart lists a TW250, which I assume is a misprint.
Barkbusters Training Bike Handguards for Suzuki TU250 '09-'12 - TwistedThrottle.com
If everyone knows about these, my apology.
Not following Z. I know they make a TU250...in fact I hope to get one in a week or two. I was referring to the barkbusters, which in the application chart below on the page shows a model for the TW. I'm a bark buster fan. These are more beefy than mine. Mine mount back to the bars inboard. These mount to the handlebar clamps with a strong mount.
I like how these have the extra bar on top of the triple-tree to hook up to. They don't have clamps that take up room on the bars themselves.
Designed for training bikes, eh? Might just hold up to normal TW use then.
15/50 sprockets, O-ring chain, D2Moto foot pegs
tweaked carb (127.5 jet, 0.019 needle shim, idle screw @2.25),
Rubbermaid "Action Packer" on homemade brackets
Look to be to big for Michigan trees. Road and 2-tracks, not off road?
I doubt they add that much width really. I ride the Michigan Cycle Conservation Club rides, so I am familiar with Michigan trails, and they look doable to me.
BTW, it will be back in Atlanta next year. Two years ago it was over by Wellston.
May 2/3 Rites of Spring XXVII Trail Tour and CCC Annual Meeting.
Trail, DS, ATV, ST • Sponsored by the Capitol Chapter.
Those Barkbuster training hand guards would make killer towel and gear drying racks for the adventure touring crowd after a long day on the trail. Also good tie down for a minimalist lean-to tarp tent's peak.
2003 TW200 "Betty Boop"
2006 TW200 "Nibbler", a.k.a. “Mr.Gizmo"
Hidden Content All Things Considered I’ld Rather Be Motorcycling