TW200 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
342 Posts
Discussion Starter #1
Here are the parts I am planning to buy for the base gasket replacement on my 2006 with 131 miles (no oil leaking yet). Am I misssing anything?



93210-72529-00 O-RING $2.69 (under cylinder)



5VC-11351-10-00 GASKET, CYLINDER $11.40



93210-13361-00 O-RING $1.33 (for dowel)

1NU-11181-00-00 GASKET, CYLINDER HEAD 1 $16.93
 

·
Registered
Joined
·
866 Posts
I ordered these as well:



90430-14131-00 - goes around one of the dowels for the head gasket

99530-14016-00 - Extra dowel pin in case one of them gets messed up during removal
 

·
Registered
Joined
·
342 Posts
Discussion Starter #3
I ordered these as well:



90430-14131-00 - goes around one of the dowels for the head gasket

99530-14016-00 - Extra dowel pin in case one of them gets messed up during removal




I will order those as well--thanks Rodney.
 

·
Registered
Joined
·
866 Posts
If you haven't already ordered, you might consider getting the o-rings for the valve adjustment covers and the cam chain cover, if you haven't replaced them in a while.
 

·
Banned
Joined
·
10,664 Posts
Some people insist on replacing the piston rings and honing the cylinder any time a top end is disassembled. If you are careful, you can remove the piston and cylinder without pulling the piston from the cylinder and not worry about what some people insist.
 

·
Registered
Joined
·
2 Posts
Is that base part number correct? 5VC-11351-10-00 GASKET



I just got a bike with the infamous leak and am ordering the replacement parts.



I am ordering 5VC-11351-01-00.
 
1 - 6 of 6 Posts
Top