TW200 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
614 Posts
Discussion Starter #1
I bent my stand and I'm not sure how much to bend it back.Can someone please post a picture of a non bent one in the up and down position or are they just a straight tube.
 

·
Registered
Joined
·
3,546 Posts
They are straight. You need to take it off before attempting to re-bend it or you will ruin the attach structure. Tubing does not take to bending very well unless heated red hot. I would take it to a welder or just buy a new one.....or live with it.
 

·
Super Moderator
Joined
·
18,061 Posts
Never hurt mine and I'm about 6 of you... :p
Do not sit on the bike with the side stand down, it will bend. It is strong enough to hold up the bike, butt not a fat butt also.
 

·
Registered
Joined
·
614 Posts
Discussion Starter #6
I was trying to kick start it on concrete so it slid a bit and bent it.My fat ass jumping on it was too much for it.I don't have any O2 for my torches so I gave it to a friend that is a welder.
 
1 - 7 of 7 Posts
Top