TW200 Forum banner

1 - 4 of 4 Posts

·
Super Moderator
Joined
·
652 Posts
Discussion Starter #1
My press plate for the multisize chain riveting tool is too big for the 428 links. I am talking about the plate with the open holes:



The holes are too far apart to the fit the 428 link size. Anyone have a press plate that fits our chain?
 

·
Registered
Joined
·
1,123 Posts
Cannot help unfortunately, I use an angle grinder with cutoff wheel and "clip-style" masterlinks... by the looks of it though you could make one pretty easy, as long as you are accurate with measurements
 

·
Registered
Joined
·
26 Posts
I'm pretty sure motion pro makes that part for the 428 chain. You could check with pro cycle. In the mean time you could press out one pin at a time. Rotate the block.
 

·
Super Moderator
Joined
·
652 Posts
Discussion Starter #4
Still can't find a press plate to fit the 428 chain. Motion pro (and all the others I have found) can break the 428 chain, but it appears a press on rivet style main link is rare for the 428, thus the chain tools don't provide a press plate for the 428. Anyone have a different experience?
 
1 - 4 of 4 Posts
Top