TW200 Forum banner
  • Hey Everyone! Enter your bike HERE to be a part of this months Bike of the Month Challenge!
1 - 2 of 2 Posts

·
Registered
Joined
·
180 Posts
Discussion Starter · #1 ·
Hello all,

I've been getting parts together to install a new clutch and a kick starter sometime in the not to distant future. I want to make sure I get everything I'm going to need on my next order. The Kick starter parts are from used bikes so I am wondering if there are any parts that commonly wear out that should be replaced with new. (diagram below)











Also I will have new springs, clutch plates, friction plates and gasket. Do I need replace any nuts or washers too? (diagram below)









Thanks for your time!!
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top