TW200 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
3,109 Posts
Discussion Starter #1
Can someone tell me where to drill when doing this mod. I intend to mod the airbox and shim accordingly but i'm still looking for better throttle response. Or would I be better off saving up for a new pumper carb?
 

·
Registered
Joined
·
2,431 Posts
You need to enlarge the existing hole in the slide, it's beside the hole the needle goes through. I used a 3/32 drill bit, it was the next size up for the hole. I'm not sure it was worth the effort to do, marginal at best.
 
1 - 3 of 3 Posts
Top