TW200 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
28 Posts
Discussion Starter #1
Hello:



Trying to get to the piliot screw on my 2009, and am stuck. I don't want to strip the float bowl drain screw (not the proper tools) Is there any tool, bit that I can run to the Auto Zone so that I can continue?



Thanks
 

·
Registered
Joined
·
866 Posts
Hello:



Trying to get to the piliot screw on my 2009, and am stuck. I don't want to strip the float bowl drain screw (not the proper tools) Is there any tool, bit that I can run to the Auto Zone so that I can continue?



Thanks


I don't think you need to remove the float bowl drain screw. Just put some rags under the carb and loosen up the bowl and take it off.
 

·
Registered
Joined
·
866 Posts
You can grind the tip of a screwdriver just enough to dull the point. That will simulate a Japanese Industrial Screwdriver. A small vice grip can be used if necessary.
 
1 - 5 of 5 Posts
Top