TW200 Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
67 Posts
Discussion Starter #1
Unfortunately I am out of town or it would take me two seconds to measure.



I am trying to design a logo to adhere to the front of the bike (the front "fender" that says Yamaha on it)



Anybody mind taking a measurement of it? Doesn't have to be exact





Thanks in advance
 

·
Registered
Joined
·
3,517 Posts
Well Dusty, only because you said "thank you". The fender off my 2006 which is hanging from the rafters does not say "Yamaha". It is 9 1/2" wide at the brace and about 5 1/2" wide at the front. From the front of the brace, to the tip (front) of the fender (down the center) is 13 1/2". Always remember, more information (in request) is better than not enough. Hope this helps...... Gerry
 
1 - 2 of 2 Posts
Top