Just remove the screw that holds that assembly to where the throttle comes through. That will allow you to raise the needle assembly. Clean the screw heads with it up. Slide it back down and use the right size screw driver to loose the 2 screws on the needle seat.They have very small threads so it is a lot of turning. You should be able to slide the needle out now.
-
Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!
Help removing needle from old style carb
Hi guys,
I picked up a beat up 1998 tw200 and am slowly restoring it. What I can't figure out is how to remove the needle. I unscrewed the top cover and can see two little screws which I think are connected to the top of the slide. Can anyone help with a recommended method of taking the slide out? I've searched the board and googled it and can't find any info.
Thanks.
I picked up a beat up 1998 tw200 and am slowly restoring it. What I can't figure out is how to remove the needle. I unscrewed the top cover and can see two little screws which I think are connected to the top of the slide. Can anyone help with a recommended method of taking the slide out? I've searched the board and googled it and can't find any info.
Thanks.
1 - 1 of 6 Posts
1 - 1 of 6 Posts
- This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
TW200 Forum
A forum community dedicated to Yamaha TW200 owners and enthusiasts. Come join the discussion about performance, exhaust, suspension, parts, modifications, troubleshooting, maintenance, and more!
Full Forum Listing
