TW200 Forum banner

1 - 12 of 12 Posts

·
Registered
Joined
·
134 Posts
Discussion Starter #1 (Edited)
All SOLD, thanks!

New in box Yamaha XT225 Kick starter Kit, PN: 3RW-W0795-00, $250.
Note: a TW200 kick lever "boss" will need to be purchased and switched out with the XT225 "boss" to work on the TW200.

DSC_0691.jpg

Basically new Yamaha carb, PN: 5FY-14301-10., it has a 128 main jet. I mounted the carb and ran the bike a couple minutes, then took it off, I ended up modifying the original carb and never used this one again. $250 and it also comes with the following new Yamaha parts:
(2) needle and seats
(1) 128 main jet
(1) 130 main jet
(1) float bowl gasket
Also (1) used carb to cylinder head manifold and some various thickness needle shims.

DSC_0690.jpg


D.I.D. 428V O-Ring chain, PN: 132FB, $70.

DSC_0692.jpg


Stock shock and spring, plus a Daytona spring, $70.It will lower the bike about 1.25"

DSC_0693.jpg



Misc. Yamaha parts, All new, $20 for all:
(1) gas tank valve, PN: 23F-24500-1
Head pipe washers, insulator washers, screws and headpiece gasket
(2) valve lash adjuster screws
(1) air box seal, PN: 1VJ-14462-00
(2) valve cover o-rings

DSC_0694.jpg DSC_0695.jpg


If you take it all, I'll make a package deal of $480. I accept PayPal and USPS Money Orders and ship via USPS Priority Mail, International orders will have a shipping charge.

.
 

·
Super Moderator
Joined
·
4,854 Posts
It would appear that you need a “TW specific” boss – the bit that goes on the spline/threaded bit that sticks out of the crankcase bit

http://tw200forum.com/forum/tw200-classifieds/18345-wanted-xt-225-kick-crank-boss-kick-start-levers-etc.html

http://tw200forum.com/forum/performance-customization/12994-kick-start-2.html (post #11)

Although the 225 parts are all quire correct for the TW200, the one exception is the TW200 “boss” – the splines are slightly different. It’s only a small easily correctable single (additional) part issue, but I thought I’d mention it before someone (like me) tried a clump hammer fix ……
 

·
Registered
Joined
·
134 Posts
Discussion Starter #7
.
OK, I opened up the XT225 crank kit and it did have the smaller XT "boss" kick lever, so a TW "boss" would need to be switched out.

.
 

·
Super Moderator
Joined
·
4,046 Posts
PayPal Sent..
 

·
Super Moderator
Joined
·
4,046 Posts
That shock would look good painted red on the Black Widow :)
Its yours pal! I don't need it. I was going to surprise you but being you brought it up.. ;)
 
1 - 12 of 12 Posts
Top