TW200 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1,931 Posts
Discussion Starter #1
I have 1-1/4" risers and CR high bend bars on my bike. I would like to switch to ATV high bend bars, but the cables seem to be too short. I am wondering if anyone has gotten this combo to work? Any tips on making it work? If not, how about getting longer cables. How would I go about getting those? I am 6'1" and would like to get the bars up higher.
 

·
Registered
Joined
·
2,410 Posts
Try re-routing the cables first.



If not, Motion Pro will make you whatever length you need. However it won't be cheap, and you may need to send them your stock cables.



The +3 inch clutch and 2 throttle cables for my SV were a bit over $100. US.



jb
 
1 - 4 of 4 Posts
Top