TW200 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
296 Posts
Discussion Starter #1
I need my triples bored out from 33mm to 36mm and the shops around here are either too busy or they cost waaaay too much for what i need done. The first set i did was with an adjustable hand reamer. It did an ok job, but i was not satisfied. Is there anyone here with a connection or has the tooling to do this? Thanks!
 

·
Registered
Joined
·
1 Posts
I need my triples bored out from 33mm to 36mm and the shops around here are either too busy or they cost waaaay too much for what i need done. The first set i did was with an adjustable hand reamer. It did an ok job, but i was not satisfied. Is there anyone here with a connection or has the tooling to do this? Thanks!
I have my own engine machine shop that specializes in powersports and such. I could set them up in the Bridgeport and bore them out. pm me
 
1 - 4 of 4 Posts
Top