TW200 Forum banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!
1 - 3 of 3 Posts

· Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hey guys,



So I'm going down the list on the service manual on what to check. It says to remove the seat and a fuse. I removed the seat and can't find the fuse! What amperage is the fuse? The only fuse that is visible to me are two yellow 20 amp fuses. Is this the fuse that it's talking about? The picture on the manual is not very descriptive on the exact location of the fuse.



Here's the scenario. 2009 TW200 won't start, the battery was dead and wouldn't charge even on the tender. Bought a new battery, after a week the bike wouldn't start up again, had to tender it to get it going, so obviously the charging system is fault somewhere on the motorcycle. I did check the battery, and it's holding charge @ 12.6 Volts.



Just trying to diagnose as to what the culprit is in the charging system.



Any help with this is greatly appreciated.
 

· Registered
Joined
·
796 Posts
Only one working fuse on a stock TW200. It is under the right side panel. The other one is a spare.

 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top