TW200 Forum banner
  • Hey Everyone! Vote for the Site Favourite BOTM winner for the year of 2022 HERE!
1 - 3 of 3 Posts

· Registered
3 Posts
Discussion Starter · #1 ·
I have an 1989 california model that has run lean for many years. I have seen in the post reference to shimmimg the needle with washers. Can anyone explain the procedure (after removing the carb) for shimming the needle. Is there a specific sequence? thanks
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.