[TW125curacao]

Electric start is not working. When i press the button, nada.
So I followed the SM troubleshooting sequence 1~3 and fuse, battery and starter motor are OK.
Step 4 is the continituity test and I heared no click and the tester gave no beep and showed 0.8.

Am I correct that to bypass I need to connect Sb to Br and L/W to B/W on the coupler?

PS
I will order a new relay but need to fix this problem first.

 

[TW125curacao]

See page 85/96 on this link for diagram:

https://www.tw-parts.com/macbig2k1/doc/tw200-2001_and_newer.pdf

 

[TW125curacao]

I tested it again and it clicks. So to the next step.

 

[TW125curacao]

Found it. Same fix, it was the connector which came loose when the pivoting bar risers broke:

Starter Doesn’t Engage and Can’t Even Bump Start

If the neutral, kill, side stand, or clutch safety switches are not functioning properly, will it still spin the starter and just stop the spark? Or does it not allow power to the starter? My 01 stalled at a red light today and would not spin the starter. I’ve had problems with my charging...

www.tw200forum.com