TW200 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
Hi, I would like to install a 2010 engine on a 1996 frame. Concerned about wiring harness compatability. Will I have to upgrade to a new ha4nwss and regulator? What else? Thanks. Mark
 

·
Super Moderator
Joined
·
17,996 Posts
You'll end up having to replace the wiring, I'm pretty sure. Not sure about the regulator and CDI.
 

·
Registered
Joined
·
338 Posts
Hi, I would like to install a 2010 engine on a 1996 frame. Concerned about wiring harness compatability. Will I have to upgrade to a new ha4nwss and regulator? What else? Thanks. Mark
All it takes is: Use the 1996 flywheel and left side (96) cover on the 2010 motor....no changes to wiring harness. You may have to use the intake manifold off the old 96 motor as well....really simple swap....
 

·
Registered
Joined
·
20,211 Posts
"And the carb boots need changing – plus the throttle cables …." Only if 2010 engine installation also includes installing the newer style carburetor too. New engine should work with old style carb and associated controls.
 
1 - 6 of 6 Posts
Top