TW200 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
6 Posts
Discussion Starter #1
OK,

So yesterday the T-Dub started and ran fine. Today I just attempted to install a new Cycle Works rear LED brake light and now the bike wont turn over. The lights did turn on initially but the brake light never engaged (grew brighter), but all else worked fine. Now the brake lights are out, but all else works, i.e., turn signal, head light, horn. The battery is fully charged and I fried two fuses at some point but they have been replaced. I am at a loss. Any thoughts?

Thank you,

CBRO
 

·
Registered
Joined
·
258 Posts
Does it turn over or not ? Kick stand down and parked in gear ? Kill switch in run position ? Basically check the easy usual suspects first .
 

·
Super Moderator
Joined
·
1,912 Posts
Fuse?
 
1 - 4 of 4 Posts
Top