TW200 Forum banner

1 - 5 of 5 Posts

·
Registered
Joined
·
30 Posts
Discussion Starter #1
I want to drill out screw the cap. just like an idea how far to go down with bit. thanks
 

·
Registered
Joined
·
5,830 Posts
This is just a guess, but I would say less than 1/16".

Don't try to drill the plug out. Just enlarge the hole enough to get a sharp pointed (i.e. drywall) screw started, then use the screw to gently wiggle and pull the plug out.
 

·
Registered
Joined
·
343 Posts
1/4"

It is just a brass plug.

The bit goes through it pretty good and quick. I just did mine with a cordless, on slow, and no stop. Light pressure. As soon as through, stop going in. ;)

Insert drywall screw and wiggle/pull out.

Done.
 
1 - 5 of 5 Posts
Top