TW200 Forum banner

1 - 8 of 8 Posts

·
Registered
Joined
·
9 Posts
Discussion Starter #1
Hi guys,

I'm installing Pro Taper SE Series 7/8" Standard Handlebars - ATV High on my '18 Tdub. My question is, what is the general consensus on cutting them down to facilitate cable routing? Do most people leave them stock, or use the measured guides to cut them down? If so, what is generally the best length to cut them down to? Can they be used stock length with the stock cables etc? Thanks!
 

·
Registered
Joined
·
1,967 Posts
I have ProTaper fat bars in ATV High bend.
No cable routing problems at all, go for it!
 

·
Registered
Joined
·
1,615 Posts
:icon_thumleft:

LIKE both of the above

May I ask where you bought and how much. When the picture debacle is fixed, I’d like to see how they look. Cheers
 

·
Registered
Joined
·
9 Posts
Discussion Starter #4

·
Registered
Joined
·
4,176 Posts
I have the Pro Taper Med bars. It gives you 1 3/4 inch rise from the stock bars. I had to cut off to the first mark to get my Bark Busters to mount properly. Sawzall works perfect for the job then followed up with a file to perfectly square up the cut.
 
1 - 8 of 8 Posts
Top