TW200 Forum banner

1 - 7 of 7 Posts

·
Banned
Joined
·
4,030 Posts
Discussion Starter #1
10663002_10203682389852350_354317059_o.jpg got the staple gun and staples from Harbor freight.
 

·
Banned
Joined
·
4,030 Posts
Discussion Starter #2
You need wide crown and 1/4 to 1/2. staples
 

·
Banned
Joined
·
4,030 Posts
Discussion Starter #3
I have more then I will ever use get the stapler and I will send you fifty.
 

·
Registered
Joined
·
19,213 Posts
Very nice offer Paul, mailing fifty staples should come in at just under an once.:) The shorter 1/4" really work great around the front of the seat where padding gets thin. My homemade cover benefited from the greeter holding ability of the longer staples towards the seats rear.
 

·
Registered
Joined
·
2,089 Posts
i got the same one. It also works good at around 85psi on the seat and on hanging insulation around 40psi. Good little staplers. My only complaint is that the stapler handle pops open now and then. NO BIGGIE considering the cost
 

·
Registered
Joined
·
3,095 Posts
Hey Zdiver1 you had mentioned something about glue in your list (from another thread) is that to glue the foam to the seat pan or ???

I'm planning on using my new Makita LXT 18 volt crown electric stapler but at $250 hardly a deal if you're only doing 1 seat :)

SAM_4379.JPG
 
1 - 7 of 7 Posts
Top