I just ordered a bunch of O-rings, oil filter and related. This means a removal of the oil filter housing. It has 2 Phillips and 1 Allen in it now. It makes me think it will take some patience to not snap something.
While the bike only has 2,250 miles on it, I need to change the chain due to a lot more rust on it than I'd like to see. I haven't counted the teeth on the sprockets yet but would like to start off on the right foot with the O-ring chain and sprockets when I figure the tooth count. As both of these repairs require screw removal I was wondering if anyone has taken the time to change them to Allen head? TIA, Gary
Stainless allen heads and milk-of-magnesia. Changed the carb float bowl and slide screws, too, as well as those on the handlebar controls. Tdub has allen heads or hex heads everywhere possible.
This is an older thread, you may not receive a response, and could
be reviving an old thread. Please consider creating a new thread.
TW200 Forum
A forum community dedicated to Yamaha TW200 owners and enthusiasts. Come join the discussion about performance, exhaust, suspension, parts, modifications, troubleshooting, maintenance, and more!
