TW200 Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
76 Posts
Discussion Starter #1
Ok, i'm trying to change sprockets, chain and replace OEM head bolts with hex head bolts.However, it seems like every other head bolt is stripped. How else can i remove these stupid head bolts. Any help would be very much appreciated.



Thanks
 

·
Registered
Joined
·
186 Posts
Ok, i'm trying to change sprockets, chain and replace OEM head bolts with hex head bolts.However, it seems like every other head bolt is stripped. How else can i remove these stupid head bolts. Any help would be very much appreciated.



Thanks


When I repalced some bolts on my T dub I had the same problem. I took a dremel and a metal grinding wheel and made them into large flat head bolts. Tapped a hammer gently on them then with some elbow grease and pressure they came out.
 

·
Registered
Joined
·
58 Posts
Are you trying to change the "head bolts" or the screws that hold the side cover? If you are talking about the screws you are probably using a #2 phillips screwdriver. If you don't own the correct JIS screwdriver then try a #3 phillips. It fits snuggly and is less prone to strip the heads.



Dan
 
1 - 3 of 3 Posts
Top