TW200 Forum banner

What to do with the Tail?

  • Put it back on

    Votes: 0 0.0%

  • Total voters
    1
1 - 15 of 15 Posts

·
Registered
Joined
·
40 Posts
Discussion Starter #1
So I was debating if I wanted to remove the tail, looking for some opinions/feedback.

Also if I decide to leave it off, I'll have to find a fender eliminator, any one have any suggestions?







 

·
Registered
Joined
·
40 Posts
Discussion Starter #3
Alright, well if I decide to put it back, I think I still should get a fender eliminator though maybe?
 

·
Registered
Joined
·
663 Posts
<jedi mind control voice>/ You don't want to put it back on. You want to leave it off. Come over to the dark side. Hollow mod it.../<end jedi mind control voice>
 

·
Registered
Joined
·
369 Posts
If you don't want mud and water hitting you in the back of the head leave it off. No way I could be without one but I primarily ride in the trails.
 

·
Registered
Joined
·
40 Posts
Discussion Starter #9
So I went out and put the tail back on but removed the bulky fender, pulled off all warning/info stickers and front reflectors, I think I'm also going to smoke the front signals.







I have an eliminator kit on order that I will be putting on either way I go.



http://i.ebayimg.com/00/$(KGrHqQOKiIE3DzvZS2IBN4t5Co5mg~~_1.JPG?set_id=8800005007
 

·
Registered
Joined
·
137 Posts
Don't listen to them, keep it off! My fender eliminator is an LED bar light from JC Whitney, and two bolts holding the plate on a piece of aluminum I bent with pliers... easy as pie, just like the TW likes it!



ROOST UP YOUR BACK IS A WAY OF LIFE




 

·
Registered
Joined
·
796 Posts
Roost? who rides in the rain without a raincoat anyways. The whole fenderless thing is set for a urban enviroment anyways. They have other options for removing the stock fender. The second picture has a seat with a FPR rear fender built in. There is also a round fender that bolts under the seat that only sticks out 2 or 3 inches. You can also hand make a fender like BMW R 1200 GS uses. Its a round fender 6 inches that hovers over the rear tire.
 

·
Registered
Joined
·
103 Posts
Don't listen to them, keep it off! My fender eliminator is an LED bar light from JC Whitney, and two bolts holding the plate on a piece of aluminum I bent with pliers... easy as pie, just like the TW likes it!



ROOST UP YOUR BACK IS A WAY OF LIFE






I need more pics of THIS bike like the other side lol. Back shot pleeeeaaaaseee



Ill post up some pics soon when I get my new taillight in. Im going to get rid of the tail section but trim down the rear plastic so it will still have that piece covering the exhaust. Im keeping it simple as this is my first riding year and cash is tight. Im doing that and a round headlight conversion. I just want to see a bike with the tail chopped like Im going to but looks like Ill be the first posting those pics since Ive searched everywhere



Oh and a fender eliminator is what? A taillight not sure what that is. Im getting a piece of angle taillight with license plate mount on it pooof done
 
1 - 15 of 15 Posts
Top