For the past two weeks I’ve been taking apart the TW200 with the fuel out the airbox issue. Being that I will be out of town for the next 3 weeks i decided I’d lightly put it all back together so nothing gets lost (3 kids). Well... i have three ziploc bags. one is the carb parts and bolts, the second is the oil parts and bolts and the third is the fairing bag with rear fender, seat and tank parts. When i was all done i had one specialized bolt left in the fairing bag. Have looked everywhere and can’t figure it out. It's not a normal bolt, so I'm figuring it is something special, and it is very possible that i put a bolt in the wrong bag at some point. I just can’t locate or remember where it goes. As normal i took lots of photos while dissemble, thought i would locate it someplace in the photo collection but didn’t. Help?
Late models have had progressively increasing numbers of buttonhead allens in places we're used to seeing hex heads. Factory ones usually have a greenish tint.
Hi all. New to the forum. I have this 200 that I've been trying to get running properly. First off, it would start, run/idle fine. For about a minute. Then, Any throttle and it would blubber and too much throttle it will die. So, it seemed like a carb problem. If I turned off the fuel, after a...
So I was replacing my deathwing with a Shinko 241 and ended up pinching the tube when removing the deathwing. I was going to patch it but decided just to buy a irc heavy duty tube but I can’t find one in a 130/80-18. Can y’all point me in the right direction? Thanks in advance.
So I have a 2019 TW.. took it in a few weeks ago for its 600 mile break in period maintenance. Got it back and rode it approximately 20 miles... first I noticed that when changing into 2nd gear the shifter is VERY stiff and have to give it my all to get it into 2nd. After the initial shift it...
My electric start randomly up and stopped working one day after a short ride, but the kick start still did so I went home and got to diagnosing. Of course, I had to do this in the least efficient way possible, so I started with disassembling the start switch to see if I had a broken wire. Nope...
I am trying to find the oem exhaust bracket that goes from the frame to the exhaust pipe and can’t find the part anywhere. The only thing I can find is the bolt that holds it into the exhaust pipe. I am in need of both bolts with any washers/lock washers and the bracket. Any help would be...
A forum community dedicated to Yamaha TW200 owners and enthusiasts. Come join the discussion about performance, exhaust, suspension, parts, modifications, troubleshooting, maintenance, and more!
