TW200 Forum banner

1 - 7 of 7 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hi guys, I need a fuel tank for my '99 TW200.



Original one is white/blue but I don't care about the color. I bought the bike to use it in the trails where I go on vacation, and the tank just started dripping. I'm leaving in 4 days.



If any of you have one for sale, please email me ! I would prefeer in canada (less trouble for me and lower shipping cost), but I have relatives in the USA that could bring it to me.



Thanks !

Luc
 

·
Registered
Joined
·
56 Posts
I have an 89 tank that is damned rusty and black and red. It would get you through if you used an inline filter. You would also have to take out the locking mechanisms on the cap because I do not have an extra key.
 

·
Registered
Joined
·
3,350 Posts

·
Registered
Joined
·
70 Posts
I've got a brand new Clark 2.8 gallon tank for sale, I can ship it tomorrow if necessary. I'll send an email.



John
 

·
Registered
Joined
·
2 Posts
Discussion Starter #6
Thanks everyone,



I bought one for a xt225... a bit expensive but I was in a rush and wanted it asap.



My old one is dripping from the outside, near the bottom. The inside rust made it through and just managed to go through the paint.

I heard about stuff that would seal it again, but also heard that the stuff didn't work most of the time.



Thanks again.
 

·
Registered
Joined
·
3,350 Posts
hey luc,



follow r80rt's directions: cut off 1/4 inch form each side metal post and grind down the rubber pads the same and fits right on. you can use the same petcock, but you'll have to trim the left side plastic a bit. i epoxied the cut off tab to the back of the plastic so it fit in the new hole.
 
1 - 7 of 7 Posts
Top