TW200 Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
10 Posts
Discussion Starter #1
I'm trying to put new turn signals on my TW. The back was straight forward, two wires coming off the new lights, two "sockets" to plug them into, but I'm stumped as to how to do the front. The lights have two wires, but I've got three "sockets." Now, I could go without the running lights, but if possible, I'd like to keep them. Do I need to get a different type of light or is there some simple harness I can throw together to make this happen?



Thanks.

Chris
 

·
Registered
Joined
·
918 Posts
Do your new lights have 2 filaments? If so, chances are each wire powers each filament individually and the ground is through the base/body/mounting bolt.



If it only has 1 filament then one wire is ground and the other for 12 volt positive.



Part number or picture or link to the lights you have??
 

·
Registered
Joined
·
10 Posts
Discussion Starter #3
Oh yeah, duh, I gotta get different lights. These are single filament, so they'll only do one or the other...Thanks! Sometimes my brain doesn't work as well as it should...



CN
 

·
Registered
Joined
·
10 Posts
Discussion Starter #4
Anyone have any idea where I can get my hands on some smaller, dual element lights? I'm not having any luck on the webs...



CM
 
1 - 4 of 4 Posts
Top