TW200 Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
221 Posts
Discussion Starter #1
We installed the XT225 tank today and installation was exactly as previoisly mentioned in numerous threads, many thanks to those that took the time to post the info.

When we went back to attach the panels that cover the tool kit and the same space on the other side......the male part of the grommet is two inches short of the female part to, secure it to the bike......... I am wondering if anyone else has had this occur on a 2015.....and what you did to remedy the situation.....

TIA
DSCN1466.JPG
 

·
Registered
Joined
·
3,359 Posts
when i trimmed the corner of the panel to clear the tank i cut the male "thingy" off with a chisel, and re-glued it where it needed to be. i'll post a pic tomorrow. 5 yrs and more than 5k miles with no problems.
 
1 - 6 of 6 Posts
Top